Never heard of them!!
One of our own innovations to stop the Roof Light scratching the roof of your vehicle.
Although you might not plan to take your light off many times, any slight movement of the magnets and the retention of dirt and water around the magnets may mark your roof. The Roof Saver is a prevention of this.

Its a clear sticky plastic sheet that is put on your roof under the Roof Light. Applied with soapy water and a squeegee to smooth in onto the roof.
With a little bit of heat (such as a hair dryer) you'll be able to remove it (but not reuse it)

It comes in different lengths and is a small price to spend on a new vehicle to keep it looking new

If you have damaged the top of your Rooflight you don't need to replace the whole thing. In this section you can buy a plastic top / hood to replace your damaged one.
Just select whic shape, size and colour you require, and fill out below if you need any text for your top.

***** Please Note these are not complete Rooflights, it is the Plastic Top / Hood Only *****

Please state Front and Rear Text required

A 12V green light for top light fixing.

In some areas, a green lamp is fixed to the top of the roof light. This is switched on and off by the Taxi Meter to indicate whether the cab is For Hire or Not. The Roof light would then be lit continuously.
It is possible for both the roof light and green light to be synchronised.

These magnets can be used on any Rooflight that needs a replacement. It is more powerful than the rectangular magnets and comes with a fixing nut and bolt, as well as a rubber boot.
The Rooflight use: -
1 for 12inch signs
2 for up to 24inch signs
3 for up to 36inch signs

The square magnets affix with two solid screws which are attached to the magnet and tightened with nuts which are supplied. They are covered in rubber to protect your vehicle roof.

These rectangular magnets are not as powerful as the round magnets but they are covered in rubber to protect your vehicle roof. You will need to use more than one to get the power to attached the Roof light to the roof.

These are replacement rubbers for the round magnets featured earlier on.
Approx Size: - 128mm / 5inch in diameter

These are sold as one bolt and one nut. They are available in three different colours, the nuts are only available in white but are never seen as under the base whne screwed on.
M5 x 13mm

Standard Roof Light plug and lead to fit any Roof lights.
Lead Length approx : 9ft

Standard Roof light plug and long lead
Aprox lead size: 15ft
Used for Mini Buses, Estates and some normal vehicles where the 9ft lead is not long enough if the light is going to the rear of the vehicle.

Standard Roof light plug. This plug will need soldering onto your lead.

Replacement Roof light socket. This will need soldering onto the lead to attach to your lights.
If you want us to we can solder a short lead on for you. Please select this option below

A rocket switch with internal light, ideal for Roof light switches. Single round hole for easy fixing. Connections are made by crimp terminals.